The effect of surface roughness parameters on frictional properties of AlSi10Mg alloy

Main Article Content

Riyadh A. Al-Samarai
Abdulsalam Y. Obaid
Y. Al-Douri

Abstract

Experimental study of the effects of surface roughness parameters and their relationship to the coefficient of friction (COF) on AlSi10Mg alloy. The information demonstrates that the average surface roughness (Ra) does not directly correlate with COF when sliding is presented. This work is focused on the relationship and interaction between the roughness parameters (Ra), maximum profile height (Rt), average profile slope, and COF. To alter the surface roughness effect, the samples of the alloy are chemically treated with an alkaline 0, 5, 10, 15, 25, and 50 minutes and tested under different circumstances. Using a T-05 block-on-ring tribometer, the COF is calculated, and surface roughness measurements are collected utilizing an optical system for measuring three-dimensional surfaces. The program MATLAB is used to analyze the obtained data. Contrarily, the results demonstrate that there is a substantial positive association with COF under sliding conditions, while Ra and Rt can change without affecting CO significantly.

Article Details

How to Cite
A. Al-Samarai, R., Obaid, A. Y. ., & Al-Douri , Y. . (2024). The effect of surface roughness parameters on frictional properties of AlSi10Mg alloy . Journal of Applied Research and Technology, 22(2), 251–257. https://doi.org/10.22201/icat.24486736e.2024.22.2.2311
Section
Articles