Optimization on Dry Sliding Wear, Electrical Resistivity and Mechanical Properties of Cu–4Cr–xZrC Composites

Main Article Content

S. Christopher Ezhil Singh
N. Selvakumar
T. Mary Little Flower

Abstract

This present study is to develop statistical model that might be used to predict the wear properties of Cu - 4Cr - xZrC (x = 0-8 wt. % of ZrC) composites have faith in densi?cation of the powder throughout compaction and sintering. The in?uence of the reinforcement, sliding distance and load on Specific Wear Rate (SWR) and Coef?cient of Friction (COF) were studied using pin-on-disc machine. L27 orthogonal array was selected for investigating the full factorial design using three factors with one replicate. Based on the main effects plots and interaction plots obtained through design was studied. Analysis of Variance (ANOVA) was used to explore the in?uencing input parameters on SWR and COF. The hardness of the composites will increase because of the increase in wt. % of ZrC. Scanning Electron Microscope (SEM), X-Ray Diffraction (XRD), pin on-disc system, Four point probe tester and Rockwell hardness tester were used to evaluate the characterization, tribological properties, electrical resistivity and hardness respectively of Cu-4Cr-xZrC composites respectively. The level of each parameter is fixed at three totally different levels, namely low, medium and high. Mathematical model was applied by design expert software so as to precise the influence degree of the most wear variables like reinforcement, sliding distance and load on SWR and COF respectively. The results indicate that the reinforcement is more dominant factor affecting SWR and COF mainly. The reinforcement plays an important role than sliding distance and load. The morphology of the worn out surfaces was analyzed to know the wear mechanisms.

Article Details

How to Cite
Singh, S. C. E., Selvakumar, N., & Flower, T. M. L. (2019). Optimization on Dry Sliding Wear, Electrical Resistivity and Mechanical Properties of Cu–4Cr–xZrC Composites. Journal of Applied Research and Technology, 16(4). https://doi.org/10.22201/icat.16656423.2018.16.4.723
Section
Articles
Author Biographies

S. Christopher Ezhil Singh

Department of Mechanical Engineering, Vimal Jyothi Engineering College, Kannur, Chemperi - 670632, Kerala, India.

N. Selvakumar

Department of Mechanical Engineering, Mepco Schlenk Engineering College, Sivakasi, Virudhunagar - 626 005, Tamilnadu. India.

T. Mary Little Flower

Department of Electronics and Communication Engineering, St. Xavier's Catholic College of Engineering, Chunkankadai, Nagercoil- 6296 003, Tamilnadu, India.

Most read articles by the same author(s)